BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL SECTION VIII FUEL SYSTEM 8-1. General. 8-Z. DacriptiOD_ The fuel cells on the Comanche consist of ayon-neoprcne bladders which are contained in cavities in the forwud sections of the wq. The main or inboard cells on ill models hold a capacity of 30 gallons each. Auxiliary cells on the PA·Z~Z50 and PA·Z4-Z60 hold a ~acity of 15 pllon. ca.ch and on the Fuel is taken from cuh cell UltoUJh a sC1'ftn located in the cell oudet and then onto the shutoff-selector valve. From the Idector the fuel is drawn throulh the sediment bowl where it is filtered and any water or sediment trapped. PA·24-400, 35 pllons each. There art no auxiliary fuel cells on the PA·24-180.

The fuel pumps. both the CftJine driven and the electric auxiliary, deliver fuel direct to the carburetor or injector. The fuel pumps on the carburetor induction systcrn aM connected pan11e1 and the pumps on the fuel injection system are connected in series. The fuel apin is filtered bdore it enters the carburetor or injector. 8-3. Fuel Ceo.. 84. Pre-Rcmoval Insuucaoftl. When necessary, for any reason. to remove the fuel cell from the caviry or to collapse it within the wi",. it is sugested that the fuel ceU be drained. then flushed. sprayed. or rubbed with a light engine oil. Do not remove the fuel cell until 24 hours have elapsed after the oil has been applied.

This will keep the cell pliable until ready to reinstall. 8·5. Ranov&!. a. Drain the fuel cell, then tum the fuel seleeror VlL1 ve to the off position. b. Remove the flat·head screws from the oval cover plate on toP.of the wing panel and remove plate. c. Disconnect the fuel sender unit wires from the unit. d. Remove the unit mounting plate bolts and washers. both at the wiDl panel opening and at the cell. Remove the sender unit plate and ,askct, being careful when sliding the plate off the drain and vent hose not to damage the unit or bend the float arm. On the outboard cell of the PA·24-400 remove the filler assembly. e.

Remove the screws attaching the "eess plate or wine f&iring to the fuel cell outlet molded nipple fitting. Loosen the damp 50 that the cell may be: drawn from the fuel line. Ј. Place tape or other protective material around thr cell aceess hole to prevent damag~ to the ceil when removIng. FUE L. SYSTEM ISSUED: 8/18/72 2 113