PIPER COMANCHE SERVICE MANUAL b. Inspect the eoupli"l (2). Use a new coupling if the old one appears deteriorated. c. Reassemble the pump with a new motor psket (11) and a new motor if required. Tilhten the motor nutS (14) JUSt snug. Be sure the couplinl (2) ellpJeS both the pump shaft and the motor shaft. d. Run the pump at free delivery with test fluid. Usc an ammeter to measure motor current. Tip motor to position it so that current is a minimum. Tilhten motor nutS to approximately 15 in. lbs, Test pump as described in pancraph 5; the 24-hO\lr Nn-in may be omined. 4. Shaft Seal Replacement. I. Remove motor and associated putS u described in Section 3.
Remove cover and associated partS as dexribed in parqraph 2. Remove the eitht YanG (6) with care to avoid damqing them. b. If I retainirIJ ring is found on "the pump shaft. tm10vuhis with suitable pliers and discard the ring. Push the rotor assembly out of the pump. Remove the housiftt insert (4). notine its position. Using I .40 to .41 diametet. flat faced brass drift a"d arbor praa., pras the shaft seal (11) OUt of the houSlng (3). Use cue to avoid darnqina the bcari", surfaces. Para may now be wuhed in a mild solvent. c. Apply a thin uniform coating of "John Crane Plastic Lad Seal No.2" to the outSide diameter of a new shah seal (12).
(This seal may be a different type than the one which wu in the pump.) With the covet end of the housing assembly on a flat surface. IIJC a 1$/16 diameter flat faced brass drift in an arbor press to ptess the shaft sca.I (12) home in the housing UlCmbly (3). d. Place the inscttion tool 8·17) oYCt the end of the rotor assembly (5). Use: motor oil to lubricate the end of the insertion tool and the rbaftsa.l. Push and twist the rotor assembly into the housing uscmbly. Install the housing insert (4). Install the YUlG (6) radius end away from center. Install the cover and associated putS per parapaph 2. Rcmewe inscttion tool. then install the motor and associated partS pc::Section 3.
Run in and tesc as described in puqraph 5. S. Performance Requirements For M.otor Driven Fuel Pumps. a. Gencn1; 1. Test fuel to be odorless minc:nl spiriu. specific gnvity .76, viscosity 1.0 cs @ i8°F. 2. Pump shall be mounted with the motor horizontal. 3. Test stand to obtain a mirlimum length of 3/8 I.D. tubing to minimize restriction to fuel flow. 4. 14 volts D.C. of the proper polarity shall be used throughout. b. Requirements: 1. Pump to be run for 24 hours at 14 volu with restricted cutlet. 2. Run pump until all air is removed from the system. 3. Restrict fue:! flow completely. 4. Check for leakage at seal. cover lasket and through cutings. 5. Restrict flow as follows: 6.
Observe for undue noise: dunng all phases of calibration. Excessive noise shall be cause for rejection. FUEL SYSTEM ISSUED: 8/18/72 2Jl1 Model No. Pressure Flow Amperes 480 Sl8-1 or 480 528 480533 15 psi 20 psi 4S JPh min. 85gph min. 5.5 mI.' Model So. Shutoff Pressure Amperes 480 S18-1 or 480528 480 S33 25 psi max. 40 psi max. 6.5 max. 10. max.