PIPER COMANCHE SERVICE MANUAL currPnt ratin,. The specified volta,e aad the current ratinc v.lues are found in paraaraph 9·Si. ! 1. If the ntaclinc is the .am. u the cal- ciliated value. proceed to part b. 2. If :eadinC is lIlueh hieber (hlfinite) than the c.lculated. value. proceed to pan b. 3. If Nadine is zero. cheek for a .bort between "NEG" aad "FLO" Ie", or for a crounded "FLO" 1 .... Circuit trac. _ill be burned open between points A.A. B.S. or C·C, Fipre 9-26. D /Ii C D 4. If re.dinl i. low, altemator field windinl is shorted. Circuit trace may be burned between points A.A. B.a. or C.C. Filunt ~26. lllGUIE '.26.
IEGUL.4TOR CHECKS MOTE To expo.e the printed circuit for riewinl, NIlOYe the bottom plate from the replator. the three p .... l board .ttacbinc scre .... the traa.istor attacbinc screw and then seperate th. heat sink from the puel board. b. With switcb turned ON. COMect voltmeter u .bown in Step.2, FilUre 9-24. Make Sute posi- tive (+) and necative (.) voltmeter lead. are connected .. shown. c. If meter reads battery volt cliscOMect Ie.:! at altemator "Fl" (field) terminal. 1. If readinl is still battery volt'Ce. -iriac is not defective. and no lIlore wirinl tests need be made. 2. If volt'Ce readinl is ,ero. the "NEG" and "FLO" leads are reversed.
Circllit trace will be burned open between points A.A. B.a. or C-C, Filure 9-26. d. If meter ntads :rero volt ..... discoanect lead at altemator "Fl" (field) terminal. and connect a jumper lead from this lead to the battery po.itive (+) pa.t. See FiCUfe ~2S. 1. If meter now read. battery votta the "POS" ad "FLO" leads are reversed. This lUisconnection alone will not cause the cizeuit trace to be burDed open. 2. If meter now reads backward altamator tield terminal i. connected to reculatornelatin terminal. the positive line is connected to telUlator field terminal. aDd recu1ator positive terminal is connected to nelative side of circuit.
Eith.r the circuit trace will be bumed between points C·C. 0-0, or E.E. Fipre ~26; or the driver transistor .ill be open. In either ca.e. the driver bias resistor will have been overbeated. e. If voltmeter reads backwards. discOftnect lead at altemator "Fl" (tield) terminal. 1. If meter still reads backwards. the "POS" IU.ld "NEG" leads .re reversed. The circuit trace may be bumed between points C.C. 0.0. E.E. or F.F. Fipre 9.26. The transient suppres- sion diode always will be open or shorted. 2. If meter now reads zero, the pclsitive Une is connected to reculator "~EG" terminal.
the nelative line is cOMected to the reculator "FLO" terminal, and the alternator 'FI" (field) ELECTRICAL SYSTEM ISSUED: 8/18n2 3 818