P'PER COMANCHE SERVICE MANUAL ~I . ~ r---, FIGURE REMOVAL OF DRIVE IND HEAD 'IGURI 9-27f. REMOVAL OF END HEAD BlARING MOTE The inner race of the slip rilll end bearilll is pressed onto the rotor shaft. When bearine replacement is nec. ... ry. always re- place the complete beatine .lembly. inclllliini the inner r.ce. f - To remove the drive end head from the rotor shaft. ale a puller that erips on the bearing retainer plate as shown in Fieure 9-27e. Do not attempt to telllOVe by supportine the end head .nd prassina on the shaft. as this may Nault in distortion of the end head or sttippine of the retaimtr plate screws.
R.move the three retainer plate screws and press the bearina out of the end head. (Refer to Filure 9-21f.) 9-61e- In .... cti.n Anti T.stin, Of eo .. po"e"... Upon completion of the disassembly. all parts should be cleaned and visually i~pected for cracks. wear or distortion and any sieftS of ever- heatina or mechanical intett.Nllee. a. Rotor: The rotor shou.ld be tested for erouaded or shorted .indinp. The croWld test can be made witll tnt probes. COMecttd in series with a lll>voh test lamp. an oIllllllltter or any type of continuity tester. (R.fer to Fiaurt 9-21,.) Thert lIIait not be any continuity between the slip rinp and the rotor shaft or poles.
To test for sborted turns in the rotor windine. connect a volt- meter. ammeter and rheoetat as shown in Fipre 9-27b. or lIIe an ohmmeter. Rotor current draw and resistance are listed in the individual specification pal"' Exces.ive current dr or a low ohmmeter readina indicates shorted wind in.. . ~o current draw or an infinite ohmmeter reading wou.ld indicate an open windine. b. Rectifie,,: A diode rectifier tester will detect and pinpoint open or shorted rectifiers without IOinl throuah the operation of disl:oMectiDl the stator leads. Ho.ever. if a tester is not available, test probes and a No. Si bulb. connected in series with a 12·Yolt battery. ean be used in the followina maMer.
Touch one test probe to a rectifier heat sink and the other test probe to ELECTRICAL SYSTEM ISSUED: 8/18n2 3 824