PIPER COMANCHE SERVICE MANUAL shoul: ~ clis3sse~bled only so far as is "ec· esserv to "'ake reoair or re.,lacel!lent of the de- fecth'e rarts , ~s a precaution, it is SURleSted tl.at safetY ,l3Ssu be worn when .!isassell\· iiinC the crankinl motor. Followina are .eneral instructions for disusemblina a typical Bendix 'iriv~ crankinl motor: a. ~emove the cover band, if present. and .!e~ach the field coil l.ads fromth.brush :'oll!ers. b. If sear reduction. n!lhove the drive heua- ing. and reduction housina. c. Remove the bolts attachine the drive 110usin. and commutator end frame to the Held fra!'!e assembly. Discard !he tane lock .ashers. d.
Separate the commutator end frame, al'\"'!ature asse!llbly, field frlme. and drive 'IGURI .. Z7u. LOCK·TORQUE TEST housin!.t. e. Remove and disusemble the drive from the Irmature shaft by fir.t identifyine the ty?e Bendix drive and then follow in a one of the auid below: 1. Standard Bendix Drive, remove the h.ad sprine screw IIld slip it off of the annature shaft. 2. Fole- Thru-8endix Drive, push in the outer anchor plate so the pilot screw or pin can be removed. NOTE Some Felo- Thru Drives use. rubber cushion in place of a drive spring. To remove from shaft. serew pinion out to drive position. then force pin from shaft throueh serew sleeve ht'les. CAUTION Do not disassemble this drive.
service is by complete replacement. 9-71. Component Inlpection And Repoir. a. Brushes and Brush Holders - Inspect the brulhes for wear. If they are worn down to one- half their orilina! length. when compared with II new brush, they should be replaced. \take sure the brush holders are clean and the brushes are not bindina in the hnlders. Tbe full brush surfac e should ride on the commutator with proper sprine tenlion (refer to test specification) to give good. firm contact. Brush leads and screws should be hlht and clean. :. Short circuits are located by rotating the armature in a erowler with a steel strip such as a hack saw blade held on the armature.
The steel strip will vibrate on the area oi the short circuit. Shorts between batS are sometimes produced by brush dust or copper between 1\e bars. Undercutting the insulation will eliminAte these shorts. 2. Opens - Inspect the pointS where ~he conductors are joined to the commutator ior loose b. Armature - The armature should be ehecked for short circuits. o~ens. and atounds: ELECTRICAL SYSTEM ISSUED: 8/18/72 '3 C12