BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 9-91. Meritods Of CII.eking G.n.,otor 0, Alt.,nato, I.lt T.nslon. a. If properly installed, tensioned and checked periodically. the pnerator or alternator drive belt will pve very satisfactory service. However, an improperly tenlion.cf belt will wear rapidly and may sUp and reduce pnerator or altemator output. Con_quently. a belt should be checked for proper tension at the time it is installed. a.ain after 2S hours operation and each 100 hours thereafter, b. There are two sati.factory lIIethod.

of checkiftl belt tension; ftowev.r the first method described will be found preferable by m~t maintenance pltScnnel because it is technically sim- ple, and requires tittle time for accCllllplishment. 1. Torque M«hod: This method of chec:kinl belt tension con.sists t:J lIIeasurine the torque requited to slip the belt at the small pulley and is accomplished a. follows: (a) Apply a torque indicatinl wrench to the nut that attaebes the pulley to the lenerator or altemator and tum it in a clockwise direction. Ob.er\'e the torque shown on the wrench at the instant the pulley slips. (b) Check the torque indicated in step (2) with torque specified in the Јol1owing chart.

HOTE The hiper tension specified for a new belt is to compen'ale for the initial stretch that takes place as SOat as it is operated. These higher tension values should not be applied to belts which pre- Viously h.\'e been used. 2. Deflection Method: Belt tension may be checked by me.surina the amowtt oi deflection caused by a predetermined amount of tension: this is accomplished in the followinl manner: (a) Attach the hook of a small spring-scale to the belt at the approximate :nid.point between the ~inll gear support and the generator or altemator.

(b) Pull on the Kale until a readina of 1~ pounds is obtained, (10 pounds ior used belts) (c) :"easute :he distance the belt has mO\'ed 'Nith the 10 to 14 !,ound load applied, The dlStanCe (deneetion) should be 5,'16 inch. If less than 5/16 inca. the belt is too tight. ELECTRICAL SYSTEM ISSUED: 8/18/72 3 C20 Width of B.lt C.. cll tion T que Indicated at _ Gener.tor or Alt.,nator Pull.y 3,8 inch 3/8 inch 1/2 inch L 2 inch New Used New Used 11 to 13 ft. lbs. 7 to 9 ft. Ibs, 13 to IS ft. lbs , 9 to 11 ft, Ibs.