BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL Before performing Iny opentiona1 test of the tnnsmitter. the foUowiftl precautions should be observed: 1.2·3. Tatin, Locacor Trmllllirter. CAtrrtON The transmitter operatn on the eMCfJency frequencies of 12 1..5 and 2043 MHz. both these frequencies are monitored by the various FAA imullations. Pmnillion mutt be obtained from the FAA/FCC Representative (or other applicable Authority) prior to tm",. Keep your tett transmission to a minima! duration. a. Remove the access panel or cover to gain access to the transmitter. b. Tunc the aircrait communications receiver to 121.5 MHz and switch the receiver ON.

deactivate squelch, and tum the receiver volume up until a slilht background noise is heard. NOTE If the aircnft is not fitted with a communications receiver, requett the tower to listen for your tnt. c. Remove the ON/ARM/OFF switch guard from the switch and set the ON/AR,\1./0FF switch to OS_ Keep the switch ON for a few seconds only: then set the switch to OFF. NOTE The tnt ttanSmlSSlon should have been picked up by the aircraft communications receiver and/or control tower. During cold weather there may be a slight delay before ttansmission occun. d. A transmitter which is functioning properly should emit a characteristic downward swept tone. e. When the test is completed.

reposition the ON/ARM/OFF switch from the OFF position to the AR.\\ position and reinstall the SWitch guard. and any access panel or COVeT removed. NOTE Whenever the unit is cheeked by movi", the seleCtor switch from the "AR.\\" to "ON" position. it must then be moved to the "OFF" positicn before reverting to the "ARM" position a,ain. ELECTRONICS ISSUED: 8/18172 3 H3