STRUCTURE, FUNCTION AND MAINTENANCE STANDARD BEVEL GEAR SHAFT, HSS, BRAKE Operation of brakes 2. Brake applied (brake pedal depressed) If the brake pedal is depressed, the brake valve switches and the oil applying back pressure to piston (7) is connected to the drain circuit. In this condition, piston (7) is pushed out to the right in the direction of the arrow by the tension of springs (2) and (3), so discs (10) and plates (9) are pressed against the stopper portion of brake outer drum (11). The brake outer drum is joined to the steering case and is fixed in posi- tion.
Therefore, the rotation of brake inner drum (12), that is the rotation of output shaft (1), is stopped because the discs and plates are pushed into contact together. The hydraulic force applied to piston (7) cab be controlled by the amount that the brake pedal is depressed, and the braking force can be adjusted. 1. Brake released When the brake is in the neutral position, the brake valve is also in the neutral position and oil enters the back-pressure port of brake piston (7). When the oil pressure rises, the oil pushes the piston to the left in the direction of the arrow, compresses springs (2) and (3), and releases the pressure pushing discs (10) and plates (9) together.
When this happens, the power trans- mitted from bevel gear shaft (16) through the HSS steering to brake inner drum (12) is trans- mitted from hub (5) to output shaft (1), and goes to the final drive. D85EX-15 10-83