STRUCTURE, FUNCTION AND MAINTENANCE STANDARD CONTROL VALVE Function This improves the response of the systsem including the pump swash plate and pressure compensation valve by sending the pilot press- sure (basic pressure of PPC valve) to the LS cir- cuit, and compensating the rise of the LS circuit pressure. Operation When lift spool (1) is at the HOLD position, pilot pressure P1 (basic pressure of PPC valve) is sent through preset check valve (3) to the cham- ber F of the pressure compensation valve. This pressure is called preset pressure P2 . At the same time, unload pressure P is being sent to chamber B , but P1 + FO > P ( FO :
load of spring (4)), so pressure compensation spool (2) moves to the left and the size of the opening between A and B becomes the maximum. When spool (1) is switched. Unload pressure P flows immediately through chambers A , B , C , D and E to lift cylinder (8), so the pressure at the port starts to rise and the time lag becomes smaller. At the same time, preset pressure P2 is supplied to LS circuit O by the timing of the spool, and the pressure in the LS circuit rises. Because of this, unload valve (7) closes, and oil is sent further to pump LS valve (6) to improve the response of the pump swash plate angle.
This makes it possible to reduce the response time for giving the necessary oil flow. D85EX-15 10-191