Komatsu — CRI ENGING CONTROL SYSTEM

STRUCTURE, FUNCTION AND MAINTENANCE STANDARD CRI ENGINE CONTROL SYSTEM 1. Fuel tank 2. Fuel supply pump assembly 2A. PCV 2B. High pressure pump 2C. Priming pump 2D. Feed pump 2E. Bypass valve 2F. G speed sensor 3. Fuel filter 4. Overflow valve 5. Common rail 6. Pressure limiter 7. Flow damper 8. Injector assembly 8A. Orifice 8B. Control chamber 8C. Hydraulic piston 8D. Injector 8E. Nozzle 9. Engine controller 10. NE speed sensor System configuration The CRI system consists of fuel supply pump (2), common rail (5), injector (8), engine control- ler (9) to control them, and sensors. The fuel supply pump generates fuel pressure in the common rail.

The fuel pressure is controlled by the fuel discharge rate of the supply pump. The discharge rate is controlled by turning on and off PCV (discharge control valve) (2A) of the fuel supply pump according to the electric sig- nals from the engine controller. The common rail receives the pressurized fuel from the fuel supply pump and distributes it to the cylinders. The fuel pressure is sensed by the common rail fuel pressure sensor installed to the common rail and controlled by the feedback method so that the actual fuel pressure will match to the com- mand pressure set according to the engine speed and the load on the engine.

The fuel pressure in the common rail is applied to the nozzle (8E) side of the injector and control chamber (8B) through the fuel injection pipe of each cylinder. The injector controls the fuel injection rate and fuel injection timing by turning on and off the TWV (2-way solenoid valve). If the TWV is turned on, the fuel circuit is so changed that the high-pressure fuel in the control chamber will flow through orifice (8A). The needle valve is raised to start fuel injection by the nozzle crack- ing pressure applied as the high-pressure fuel on the nozzle side.

If the TWV is turned off, the fuel circuit is so change that the high-pressure fuel will be applied to the control chamber through the orifice. As a result, the needle valve lowers and finishes fuel injection. Accordingly, the fuel injection timing and fuel injection rate are con- trolled respectively by the timing to turn on the TWV and the length of the turn-on time of the TWV. D85EX-15 10-215