Komatsu — MONITOR SYSTEM

STRUCTURE, FUNCTION AND MAINTENANCE STANDARD MONITOR SYSTEM Processing in monitor panel (Common to all specifications) Display of monitor panel Display of monitoring condition Other items a See TESTING AND ADJUSTING, Special functions of monitor panel (EMMS). D85EX-15 10-217 (1) Contents and conditions of processing (2) Method (3) Flow of signals 1) Display of travel direction and gear speed. F1, R3, etc. are notified by CAN according to information of transmission and steering controller. 2) Display of gauges of engine speed, engine water tem- perature, etc. Controller converts the sensor signals into gauge num- bers and sends them to the monitor panel by CAN.

3) Display of trouble When the machine has a trouble, the corresponding fail- ure code is notified to the monitor panel by CAN. Which one should be turned on, the buzzer or the cau- tion lamp, is notified, too. (a) In normal state User code (b) In trouble history display mode The service code (6-digit code) and the fol- lowing items are displayed 1. Time after first occurrence 2. Time after latest occurrence 3. Number of past occurrences The monitor panel displays the code on the multi insfor- mation section.

CAN CAN Each sensor/solenoid–controller– monitor panel (1) Contents and conditions of processing (2) Method (3) Flow of signals 1) The communication conditions of each sensor, each so- lenoid, and CAN are displayed. The item Nos. and device conditions are notified to the monitor panel by CAN. The monitor panel displays the items and each value on its multi-information section. 2) Each items is selected by using the cursor switches, se- lector switches, buzzer cancel switch, and shift UP/ DOWN switches.

CAN Each sensor–controller–monitor panel (1) Contents and conditions of processing (2) Method (3) Flow of signals 1) Function selection mode (Displayed each time cancel switch is turned to left) (a) Replacement periods of oil filter and oil are displayed. (b) Engine speed, oil pressure in work equipment circuit, etc. are displayed. (c) Failure codes related to electronic control are displayed. (d) Brightness of display, etc. are adjusted. 2) Mode to change replacement periods of maintenance mode 3) Mode to display failure codes related to machine body such as overheating, abnormal water temperature, etc. 4) Mode to display service meter and information related to load on machine — —