TESTING AND ADJUSTING MEASURING INTAKE AIR PRESSURE (BOOST PRESSURE) MEASURING INTAKE AIR PRESSURE (BOOST PRESSURE) a Insert the joint of the gauge and hose half- way and open the self-seal on the hose side repeatedly, and the oil is drained. a If Pm kit (A) is available, the air bleeding cou- pling (790-261-1130) in it may be used. a If any oil is left in the hose, the gauge does not move. Accordingly, be sure to drain the oil. a Measuring instruments for intake air pressure (boost pressure) 5. Run the engine at high idling and stall the torque converter and measure the intake air pressure (boost pressure) at this time.
a For the procedure for stalling the torque con- verter, see MEASURING ENGINE SPEED. a Normally, the intake air pressure (boost pres- sure) should be measured while the engine is operated at the rated output. In the field, however, an approximate value can be obtained by stalling the torque converter. When installing and removing the measuring instrument, take care not to touch a hot part. a Measure the intake air pressure (boost pressure) under the following condition. Engine water temperature: Within operating range Power train oil temperature: Within operating range Hydraulic oil temperature: Within operating range 1. Open the right side cover of the engine. 2.
Remove air intake connector boost pressure pick-up plug (1). 6. After finishing measurement, remove the mea- suring instrument and return the removed parts. 3. Install nipple [1] of boost gauge kit A and con- nect gauge [2]. 4. Run the engine at medium or higher speed and drain the oil from the hose. 20-108 D85EX-15 (1) Symbol Part No. Name A 799-201-2202 Boost gauge kit