TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS) 11. Dual display monitoring mode (11-DUAL DISPLAY MONITORING MODE) In this mode, 2 monitored items can be displayed simultaneously. a Note that only codes and monitoring informa- tion are displayed in this mode since the usable display columns are limited. (Item names and units cannot be displayed.) 1) Selecting and executing mode i) Select “Dual display monitoring mode” on the mode selection screen. a If the mode is selected, code (dR) is displayed on gear speed display sec- tion (1) and the title is displayed on multi-information section (2). ii) Display the monitoring code input screen by operating buzzer cancel switch (4).
[ ]: Execute mode. 2) Selecting and entering monitored items i) On the code input screen, input the 5- digit codes of the items to be monitored to the upper and lower lines by operating information switch (5), shift-up switch (6), and shift-down switch (7). [ > ]: Move cursor to right. [ Move cursor to left. [UP]: Increase number. [DOWN]: Decrease number. ii) After inputting the codes, display the monitoring screen by operating buzzer cancel switch (4). [ ]: Enter input code. a If the input codes are normal, the monitoring screen shown at right appears. D85EX-15 20-199 (1)