Komatsu — ERROR CODE [15SAL1] (FORWARD CLUTCH:SEE THE LIST.(L1))

TROUBLESHOOTING ERROR CODE 15SAL1 ERROR CODE 15SAL1 (FORWARD CLUTCH: SEE THE LIST. (L1)) Circuit diagram related to transmission forward clutch ECMV 20-408 D85EX-15 (1) Action co de Error code Controller code F Trouble ( orward clutch: See the list. (L1) Steering and transmission controller system) CALL E0 3 15SAL1 Steering and transmission Contents trouble of • The fill switch signal is not set off at output stop of the transmission forward clutch solenoid circuit. Action o controlle • Flashes caution lamp and turns on caution buzzer. f • Decides that engine speed is neutral (N) at reverse operation. r • Limits operation of engine and transmission.

Problem t appears machin hat • Once machine is stopped, engine speed is limited to medium (half). on • Once machine is stopped, running is limited to F1. e Related informati • The input state (ON/OFF) from the forward clutch fill switch can be checked in monitoring mode. (Code 31520: Transmission fill switch input state) on • Method of reproducing error code:

Engine start + Neutral running Possible cau and standar value in nor state Cause Defective forward clutch fill 1 switch (Internal short) Defective harness ground- ses 2 ing (Contact with ground cir- d cuit) mal Defective steering and 3 transmission controller Defective hydraulic pres- 4 sure system Standard value in normal state/Remarks on troubleshooting Defective forward clutch fill switch (Internal short) aPrepare with starting switch OFF, then start the engine for trouble- shooting. FFT (male) PCCS lever Resistance Between (1) – chassis ground N Min. 1Mz F (Forward) Max.

1z Defective harness ground- ing (Contact with ground cir- cuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC2 (female) (35) – R FFT (female) (1) with chassis ground esistance Max. 1Mz Defective steering and transmission controller aPrepare with starting switch OFF, then start the engine for trouble- shooting. STC2 PCCS lever Voltage Between (35) – chassis ground N 20 – 30V F (Forward) Max. 1V Defective hydraulic pres- sure system When no fault is detected in the electric system, the hydraulic pressure system is assumed to be abnormal. Carry out the related troubleshoot- ing (H mode).