Komatsu — ERROR CODE [AD51KB] (FUEL SUPPLY PUMP SOLENOID 2:DISCONNECTION IN SHORT (KB))

TROUBLESHOOTING ERROR CODE AD51KB ERROR CODE AD51KB (FUEL SUPPLY PUMP SOLENOID 2: DISCONNECTION IN SHORT (KB)) Circuit diagram related to fuel supply pump solenoid 2 D85EX-15 20-427 (1) Action cod e Error code Controller code Trouble Fuel supply pump solenoid 2: Short (KB) (Engine controller system) CALL E0 3 AD51KB ENG Contents trouble of • Overcurrent occurred in fuel supply pump solenoid 2 (PCV2). Action of controller • Flashes caution lamp and turns on caution buzzer. • Limits engine and transmission operation. • Stops output to fuel supply pump solenoid 2 circuit. Problem th appears o machine at • Once machine is stopped, engine speed is limited to medium (half).

n • Once machine is stopped, running is limited to F1 and R1. • If codes [AD11KA] and [AD11KB] are displayed at the same time, engine stops. Related informatio • The special adapter (799-601-9430) is necessary for troubleshooting of fuel supply pump solenoid 2. n • Method of reproducing error code:

Engine start Possible cau and standard value in norm state Cause Defective fuel supply pump 1 solenoid 2 (Internal discon- nection in wiring) Defective harness ground- 2 ing (Contact with ground cir- cuit) ses P al Defective harness hot short 3 (Contact with 24V circuit) P P 4 Defective engine controller Standard value in normal state/Remarks on troubleshooting Defective fuel supply pump solenoid 2 (Internal discon- nection in wiring) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. PCV2 (male) Resistance Between (1) – (2) 2.3 – 5.3z Between (1) – chassis ground Min.

1Mz Defective harness ground- ing (Contact with ground cir- cuit) P aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between EGC3 (female) (13) – CV2 (female) (1) Resistance Max. 1Mz Defective harness hot short (Contact with 24V circuit) P P aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between EGC3 (female) (13) – CV2 (female) (1) with chassis ground Voltage Max. 1V Wiring harness between EGC3 (female) (23) – CV2 (female) (2) with chassis ground Voltage Max.

1V Defective engine controller aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. EGC3 (male) Resistance Between (13) – (23) 2.3 – 5.3z Between (13) (23) – chassis ground Min. 1Mz