Komatsu — ERROR CODE [D5ZFKA] (TRANSMISSION NEUTRAL SIGNAL: DISCONNECTION (KA))

TROUBLESHOOTING ERROR CODE D5ZFKA ERROR CODE D5ZFKA (TRANSMISSION NEUTRAL SIGNAL: DISCONNECTION) (KA) Circuit diagram related to transmission neutral signal 20-454 D85EX-15 (1) Action code Error code Controller code T Trouble ( ransmission neutral signal: Disconnection (KA) Steering and transmission controller system) E01 D5ZFKA Steering and transmission Contents of • trouble The transmission neutral signal output line is disconnected. • Action of controller • This signal line is for backing up (The main signal is transmitted through the CAN communication net- work). Stops outputting the transmission neutral signal. Problem that appears on • machine None in particular.

• Related information • The state of the transmission neutral signal can be checked in monitoring mode (Code: 40909 input signal) (Code: 40901 input signal). Method of reproducing error code: Turn starting switch ON and shift transmission in N position. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Disconnection in wiring har- ness (Disconnection in wir- 1 ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC2 (female) (19) – EGC3 (female) (7), (17) Resistance M ax.

1z Short circuit with chassis 2 ground in wiring harness (Contact with ground circuit) ( aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between STC2 female) (19) – EGC3 (female) (7), (17) with chassis ground Resistance Min. 1 Mz Defective steering and 3 transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between STC2 (fe- male) (19) – ground Lever in N Voltage Max. 1V Lever in F or R Voltage 2 0 – 30V 4 Defective engine controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

Between EGC3 (7), (17) – ground Voltage Ap prox. 7 V