TROUBLESHOOTING ERROR CODE DAFRKR ERROR CODE DAFRKR (MONITOR PANEL CAN COMMUNICATION: DEFECTIVE COMMUNICATION (KR)) 20-456 D85EX-15 (1) Action code Error code Controller code Trouble Monitor panel CAN communication: Defective communication (KR) (Monitor panel system) CALL E03 DAFRKR MON Contents of trouble • Monitor panel cannot recognize steering and transmission controller with CAN communication circuit. Action of controller • Flashes caution lamp and turns on caution buzzer. • Limits operation of engine and transmission. Problem that appears on machine • System may not operate normally. • Once machine is stopped, engine speed is limited to medium (half).
• Once machine is stopped, travel is limited to F1 and R1. Related information • Method of reproducing error code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between S04 (female) (1), (2) – STC2 (female) (32) – EGC2 (female) (32) – CA1 (female) (A) – CA2 (female) (A) Resistance Max.
1z Wiring harness between S04 (female) (3) (4) – STC2 (female) (22) – EGC2 (female) (22) – CA1 (female) (B) – CA2 (female) (B) Resistance Max. 1z 2 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between S04 (female) (1), (2) – STC2 (female) (32) – EGC2 (female) (32) – CA1 (female) (A) – CA2 (fe- male) (A) with chassis ground Resistance Min. 1Mz Short circuit of wiring harness between S04 (female) (3), (4) – STC2 (female) (22) – EGC2 (female) (22) – CA1 (female) (B) – CA2 (fe- male) (B) with chassis ground Resistance Min.
1Mz 3 Hot short circuit in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between S04 (female) (1), (2) – STC2 (female) (32) – EGC2 (female) (32) – CA1 (female) (A) – CA2 (fe- male) (A) with chassis ground Voltage Max. 1V hort circuit of wiring harness between S04 (fe- male) (3), (4) – STC2 (female) (22) – EGC2 (female) (22) – CA1 (female) (B) – CA2 (fe- male) (B) with chassis ground Voltage Max. 1V 4 Defective CAN terminal re- sistance aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
CA1 (male), CA2 (male) Resistance Between (A) – (B) 40 – 80z 5 Defective monitor panel or defective steering and transmission controller If no problem is found in causes 1 to 4, it is suspected that monitor pan- el or steering and transmission controller is defective. (Troubleshoot- ing cannot be carried out since it is internal defect.)