Komatsu — ERROR CODE [DAQ5KK] [DB35KK] (STEERING AND TRANSMISSION CONTROLLER SENSOR 5V POWER SUPPLY:SOURCE VOLTAGE REDUCTION/INPUT (KK))

TROUBLESHOOTING ERROR CODE DAQ5KK DB35KK ERROR CODE DAQ5KK DB35KK (STEERING AND TRANSMISSION CONTROLLER SENSOR 5V POWER SUPPLY: SOURCE VOLTAGE REDUCTION/INPUT (KK)) 20-460 D85EX-15 (1) Action code Error code Controller code Trouble Steering and transmission controller potentiometer power sup- ply: Source voltage reduction/input (KK) (Steering and transmission controller system) CALL 03 DAQ5KK DB35KK Steering and transmission Contents of trouble • Voltage of 5V power supply circuit of steering and transmission controller sensor is below 4.5V or above 5.5V. • Abnormal current flowed in 5V power supply circuit of steering and transmission controller sensor.

Action of controller • Flashes caution lamp and turns on caution buzzer. • Stops output to 5V power supply circuit if abnormal voltage flows • Limits operation of engine and transmission. Problem that appears on machine • System may not operate normally. • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 an R1. Related information • Both of DAQ5KK and DB35KK are displayed. • Method of reproducing error code: Turn starting switch ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective brake potentiom- eter (Internal short circuit) When the connector shown at right is disconnected, if the service code is lighted up (to indicate returning to normal), the cause is an internal trouble. aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. BRK connector 2 Defective forward-reverse potentiometer (Internal short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

TL2 (male) Resistance Sensor 1 (FR3) Between (4) – (1) 2kz ± 20% Between (4) – chassis ground Min. 1Mz 3 Defective steering potenti- ometer (Internal short cir- cuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. TL1 (male) Resistance Sensor 1 (ST1) Sensor 2 (ST2) Between (A) – (G) 3.2kz ± 20% Between (A) – chassis ground Min. 1Mz 4 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

Short circuit of wiring harness between STC1 (female) (22) – TL2 (female) (5), – TL2 (fe- male) (4), – BRK (female) (C) with chassis ground Resistance Min. 1Mz 5 Hot short circuit in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC1 (female) (22) – TL2 (female) (5), – TL2 (fe- male) (4), – BRK (female) (C) with chassis ground Voltage Max. 1V 6 Defective steering and transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (22) – (21) 4.5 – 5.5V