TROUBLESHOOTING ERROR CODE DK30KA ERROR CODE DK30KA (STEERING POTENTIOMETER 1: DISCONNECTION (KA)) 20-508 D85EX-15 (5) Action code Error code Controller code Trouble Steering potentiometer 1: Disconnection (KA) (Steering and transmission controller system) CALL E03 DK30KA Steering and transmission Contents of trouble • Signal voltage of steering potentiometer 1 system is below 0.5V. Action of controller • Flashes caution lamp and turns on caution buzzer. • Continues controlling with signal of steering potentiometer 2 system. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half).
• Once machine is stopped, travel is limited to F1 and R1. Related information • Input (Voltage) from steering potentiometer 1 can be checked in monitoring mode. (Code 50300: Voltage of steering potentiometer 1) • Method of reproducing error code: Turn starting switch ON and operate PCCS lever (for steering). Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective 5V sensor power source system See if error code [DAQ5KK] [DB35KK] is displayed. If it is displayed, carry out troubleshooting for it first.
2 Defective steering potenti- ometer 1 (Internal discon- nection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. TL2 (male) Resistance Between (5) – (8) 3.2kz ± 20% Between (7) – (5) 1 – 6 kz (Right – Left steering) Between (7) – (8) 6 – 1 kz (Right – Left steering) 3 Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC1 (female) (22) – TL2 (female) (5) Resistance Max. 1z Wiring harness between STC1 (female) (2) – TL2 (female) (7) Resistance Max.
1z 4 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between STC1 (female) (2) – TL2 (female) (7)H with chassis ground Resistance Min. 1Mz 5 Defective steering and transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (2) – (21) 0.5 – 4.5V