TROUBLESHOOTING ERROR CODE DK56KB ERROR CODE DK56KB (FORWARD-REVERSE POTENTIOMETER 1: SHORT CIRCUIT (KB)) Circuit diagram related to forward-reverse potentiometer D85EX-15 20-523 (5) Action co de Error code Controller cod e Fo Trouble (St rward-reverse potentiometer 1: Short circuit (KB) eering and transmission controller system) CALL E0 3 DK56KB Steering and transmission Contents trouble of • Signal voltage of forward-reverse potentiometer 1 system is above 4.5V. Action o controlle • Flashes caution lamp and turns on caution buzzer. f • Continues controlling with signal of forward-reverse potentiometer 2 system. r • Limits operation of engine and transmission.
Problem t appears machin hat • Once machine is stopped, engine speed is limited to medium (half). on • Once machine is stopped, travel is limited to F1 and R1. e Related informati • Input (Voltage) from forward-reverse potentiometer 1 can be checked in monitoring mode. (Code 50200: Voltage of forward-reverse potentiometer 1) on • Method of reproducing error code: Turn starting switch ON and operate PCCS lever (for forward/re- verse travel).
Possible cau and standar value in nor state Cause Defective 5V sensor power 1 source system Defective forward-reverse potentiometer 1 (Internal 2 disconnection or short cir- ses cuit) d mal Short circuit with power 3 source in wiring harness (Contact with 24V circuit) Defective steering and 4 transmission controller Standard value in normal state/Remarks on troubleshooting Defective 5V sensor power source system See if error code [DB35KK] [DAQ5KK] is displayed. If it is displayed, carry out troubleshooting for it first.
Defective forward-reverse potentiometer 1 (Internal disconnection or short cir- cuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. TL2 (male) Resistance Between (4) – (1) 3.2kz ± 20% Between (2) – (4) 5.5 – 1.5 kz (Forward – Reverse) Between (2) – (1) 1.5 – 5.5 kz (Forward – Reverse) Short circuit with power source in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC1 (female) (2) – TL2 (female) (2) with chassis ground Resistanc e Max.
1V Defective steering and transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (7) – (21) 0.5 – 4.5V