TROUBLESHOOTING ERROR CODE DKH1KA ERROR CODE DKH1KA (PITCH ANGLE SENSOR: DISCONNECTION (KA)) Circuit diagram related to pitch angle sensor D85EX-15 20-527 (1) Action cod e Error code Controller code Trouble Pitch angle sensor: Disconnection (KA) (Steering and transmission controller system) CALL E03 DKH1KA Steering and transmission Contents o trouble f • Signal voltage of pitch angle sensor is below 0.15V. Action of controller • Flashes caution lamp and turns on caution buzzer. • Cannot recognize pitch angle. • Limits operation of engine and transmission. Problem th appears on machine at • Shocks are made when gear is shifted on slope and when machine is steered on level place.
• Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. Related information • Input (Voltage) from pitch angle sensor can be checked in monitoring mode. (Code 60100: Voltage of pitch angle sensor) • Method of reproducing error code: Turn starting switch ON.
Possible caus and standard value in norm state Cause Defective 24V power source 1 system Defective pitch angle sen- 2 sor (Internal trouble) Disconnection in wiring har- es ness (Disconnection in wir- 3 ing or defective contact in al connector) Short circuit with chassis 4 ground in wiring harness (Contact with ground circuit) Defective steering and 5 transmission controller Standard value in normal state/Remarks on troubleshooting Defective 24V power source system See if error code [DAQ6KK] [DB36KK] is displayed. If it is displayed, carry out troubleshooting for it first.
Defective pitch angle sen- sor (Internal trouble) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. PT2 Voltage Between (B) – (A) 0.15 – 4.85V Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC1 (female) (16) – PT2 (female) (C) Resistance Max. 1z Wiring harness between STC1 (female) (13) – PT2 (female) (B) Resistance Max.
1z Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between STC1 (female) (8) – PT2 (female) (B) with chassis ground Resistance Min. 1Mz Defective steering and transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (8) – (21) 0.15 – 4.85V