Komatsu — ERROR CODE [DXH7KB] (REVERSE CLUTCH ECMV:SHORT CIRCUIT (KB))

TROUBLESHOOTING ERROR CODE DXH7KB ERROR CODE DXH7KB (REVERSE CLUTCH ECMV: SHORT CIRCUIT (KB)) Circuit diagram related to transmission reverse clutch ECMV D85EX-15 20-551 (1) Action code Error code Co ntroller code Trouble Reverse clutch ECMV: Short circuit (KB) (Steering and transmission controller system) CALL E03 St DXH7KB tr eering and ansmission Contents of trouble • When signal was output to transmission reverse clutch solenoid circuit, abnormal current flowed. Action of controller • Flashes caution lamp and turns on caution buzzer. • Stops outputting to transmission reverse clutch solenoid circuit. • Limits operation of engine and transmission.

Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1. Related information • Output (Current) to reverse clutch solenoid can be checked in monitoring mode. (Code 31606, 31616: Output current of reverse clutch ECMV) • Method of reproducing service code: Start engine and drive machine in reverse.

Possible causes and standard value in normal state Cause Defective reverse clutch 1 ECMV (Internal short cir- cuit) Short circuit with chassis 2 ground in wiring harness (Contact with ground circuit) Short circuit in wiring har- 3 ness (with another wiring harness) Defective steering and 4 transmission controller Standard value in normal state/Remarks on troubleshooting aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. SRT (male) Resistance Between (1) – (2) 5 – 25z Between (1) – chassis ground Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

Short circuit of wiring harness between STC (female) (37) – SRT (female) (1) with chassi ground 3 s Resistance Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit in wiring harness between STC (female) (37) – SRT (female) (1) with wiring harness between STC3 (female) (13) – SRT (female) (2) 3 Resistance Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. STC3 Resistance Between (37) – (13) 5 – 25z Between (37) – chassis ground Min. 1Mz