Komatsu — ERROR CODE [DXH8KB] (FORWARD CLUTCH ECMV:SHORT CIRCUIT (KB))

TROUBLESHOOTING ERROR CODE DXH8KB ERROR CODE DXH8KB (FORWARD CLUTCH ECMV: SHORT CIRCUIT (KB)) Circuit diagram related to transmission forward clutch ECMV D85EX-15 20-553 (1) Action code Error code Co ntroller code Trouble Forward clutch ECMV: Short circuit (KB) (Steering and transmission controller system) CALL E03 St DXH8KB tr eering and ansmission Contents of trouble • When signal was output to transmission forward clutch solenoid circuit, abnormal current flowed. Action of controller • Flashes caution lamp and turns on caution buzzer. • Stops outputting to transmission forward clutch solenoid circuit. • Limits operation of engine and transmission.

Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to R1. Related information • Output (Current) to forward clutch solenoid can be checked in monitoring mode. (Code 31608, 31622: Output current of forward clutch ECMV) • Method of reproducing service code: Start engine and drive machine forward.

Possible causes and standard value in normal state Cause Defective forward clutch 1 ECMV (Internal short cir- cuit) Short circuit with chassis 2 ground in wiring harness (Contact with ground circuit) Short circuit in wiring har- 3 ness (with another wiring harness) Defective steering and 4 transmission controller Standard value in normal state/Remarks on troubleshooting aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. SFT (male) Resistance Between (1) – (2) 5 – 25z Between (1) – chassis ground Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

Short circuit of wiring harness between STC3 (female) (27) – SFT (female) (1) with chassis ground Resistance Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit in wiring harness between STC3 (female) (27) – SFT (female) (1) with wiring harness between STC3 (female) (13) – SFT (female) (2) Resistance Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. STC3 Resistance Between (27) – (13) 5 – 25z Between (27) – chassis ground Min. 1Mz