TROUBLESHOOTING E-19 E-19 THE INFORMATION SWITCH DOES NOT WORK. 20-626 D85EX-15 (1) Trouble • The information switch does not work. Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective information switch (Internal short circuit or dis- connection) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. CUR (male) Information switch Resistance Between (1) and (2) OFF (0) Min. 1Mz > Max. 1z Between (1) and (3) OFF (0) Min. 1Mz Max.
1z 2 Disconnection of wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Wiring harness between STC2 (16) and CUR (female) Resistance Max. 1z Wiring harness between STC2 (6) and CUR (fe- male) (3) Resistance Max. 1z Wiring harness between CUR (female) (1) and ground Resistance Max. 1z 3 Ground fault of wiring har- ness (Contact with ground circuit) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Between wiring harness (between STC2 (16) and CUR (female) (2)) and ground Resistance Min.
1Mz Between wiring harness (between STC2 (6) and CUR (female) (3)) and ground Resistance Min. 1Mz 4 Defective steering controller aPrepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. Steering and trans- mission controller Buzzer cancel switch Voltage Between STC2 (16) and STC3 (21), (31), (32), (33) OFF (0) 20 – 30V Max. 1z Between (6) and ground OFF (0) 20 – 30V > Max. 1V