Komatsu — E-24 MALFUNCTION OF WIPERS

TROUBLESHOOTING E-24 E-24 MALFUNCTION OF WIPERS D85EX-15 20-635 (1) Trouble (1) • The front wiper does not operate (Continuous operation is defective). Related information • Carry out the following troubleshooting when only the front wiper is defective. • If fuse (5) in the cab is broken, intermittent operation of the all wipers becomes defective. • If any wiper does not operate, check the fusible link (96A). • When carrying out the troubleshooting, turn the intermittent switch OFF and turn the wiper switch ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective circuit breaker (96A) If the circuit breaker is turned OFF, the circuit probably has a grounding fault, etc. 2 Defective fuse (5) in cab Since fuse (5) in the cab is used for the front wiper system and inter- mittent switch system, those systems probably have a grounding fault, etc. 3 Defective front wiper motor aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between CN23 (6) – ground Voltage 20 – 30V aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

Wiring harness between CN23 (female) (1) – ground Resistance Max. 1z 4 Defective front wiper switch aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CN14 (male) Position of switch Resistance Between (3) – (4) ON Max. 1z OFF Min. 1 Mz 5 Defective front wiper inter- mittent selector relay • If the trouble is repaired by replacing the relay with relay CN27, CN31, or CN33, the relay is defective. aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

Between CN29 (3) – ground Voltage 20 – 30V Between CN29 (6) – ground Voltage 20 – 30V Between CN29 (1) – ground Voltage 20 – 30V 6 Defective front wiper inter- mittent relay • If the trouble is repaired by replacing the relay with relay CN26, CN30, or CN32, the relay is defective. aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

Between CN28 (4) – ground Voltage 20 – 30V Between CN28 (3) – ground Voltage 20 – 30V Between CN28 (5) – ground Voltage 20 – 30V 7 Disconnection or short cir- cuit with chassis ground in wiring harness (Disconnec- tion in wiring or defective contact in connector or con- tact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CN14 (female) (4) – CN29 (female) (3) Resistance Max. 1z Contact of wiring harness between CN14 (fe- male) (4) – CN29 (female) (3) with ground Resistance Min. 1 Mz Wiring harness between CN29 (female) (6) - CN28 (female) (4) Resistance Max.

1z Contact of wiring harness between CN29 (fe- male) (6) – CN28 (female) (4) with ground Resistance Min. 1 Mz