TROUBLESHOOTING E-24 D85EX-15 20-647 (1) Trouble (7) • The left door wiper does not operate (Continuous operation is defective). Related information • Carry out the following troubleshooting when only the left door wiper is defective. (If fuse (6) in the cab is broken, the right door wiper does not operate either.) • If any wiper does not operate, check the fusible link (96A). • When carrying out the troubleshooting, turn the intermittent switch OFF and turn the wiper switch ON.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective circuit breaker (96A) If the circuit breaker is turned OFF, the circuit probably has a grounding fault, etc. 2 Defective fuse (6) in cab Since fuse (6) in the cab is used for the left door wiper system and left door wiper system, either of those systems probably has a grounding fault, etc. 3 Defective left door wiper motor aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.
Between connector (3) just before motor – ground Voltage 20 – 30V aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between connector (1) just be- fore motor – ground Resistance Max. 1z 4 Defective left door wiper switch aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CN15 (male) Position of switch Resistance Between (3) – (4) ON Max. 1z OFF Min. 1 Mz 5 Defective left door wiper in- termittent selector relay • If the trouble is repaired by replacing the relay with relay CN29, CN31, or CN33, the relay is defective.
aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between CN31 (3) – ground Voltage 20 – 30V Between CN31 (6) – ground Voltage 20 – 30V Between CN31 (1) – ground Voltage 20 – 30V 6 Defective left door wiper in- termittent relay • If the trouble is repaired by replacing the relay with relay CN28, CN30, or CN32, the relay is defective. aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.
Between CN26 (4) – ground Voltage 20 – 30V Between CN26 (3) – ground Voltage 20 – 30V Between CN26 (5) – ground Voltage 20 – 30V 7 Disconnection or short cir- cuit with chassis ground in wiring harness (Disconnec- tion in wiring or defective contact in connector or con- tact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CN15 (female) (4) – CN27 (female) (3) Resistance Max. 1z Contact of wiring harness between CN15 (fe- male) (4) – CN27 (female) (3) with ground Resistance Min. 1 Mz Wiring harness between CN27 (female) (6) – CN26 (female) (4) Resistance Max.
1z Contact of wiring harness between CN27 (fe- male) (6) – CN26 (female) (4) with ground Resistance Min. 1 Mz