Komatsu — E-25 WASHING WATER DOES NOT COME OUT

TROUBLESHOOTING E-25 * For the electric circuit diagram of each system, see Trouble (1). D85EX-15 20-653 (1) Trouble (2) • Washing water of the rear washer does not come out. Related information • Carry out the following troubleshooting when the rear wiper operates normally. (If the wiper does not operate either, carry out troubleshooting in E-24 THE WIPER DOES NOT OPERATE first. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective rear washer motor aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between 364 (male) (2) – ground Resistance Max.

1z aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between 364 (2) – ground Voltage 20 – 30V 2 Defective rear wiper switch aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CN12 (female) Position of switch Resistance Between (2) – (1) W/ or W/ Max. 1z OFF Min. 1 Mz 3 Disconnection or short cir- cuit with chassis ground in wiring harness (Disconnec- tion in wiring or defective contact in connector or con- tact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

Wiring harness between fuse (4) – CN12 (fe- male) (2) Resistance Max. 1z Contact of wiring harness between fuse (4) – CN12 (female) (2) with ground Resistance Min. 1 Mz Wiring harness between CN12 (female) (1) – 19 (4) – 364 (female) (1) Resistance Max. 1z Contact of wiring harness between CN12 (fe- male) (6) – 19 (4) – 364 (female) (1) with ground Resistance Min. 1 Mz Wiring harness between 364 (female) (2) – ground Resistance Max. 1z