DISASSEMBLY AND ASSEMBLY HOW TO READ THIS MANUAL HOW TO READ THIS MANUAL REMOVAL AND INSTALLATION OF ASSEMBLIES SPECIAL TOOLS INSTALLATION OF PARTS Special tools that are deemed necessary for removal or installation of parts are listed. List of the special tools contains the following kind of information 1) Necessity t : Special tools which cannot be substi- tuted, should always be used. q : Speciall tools which are very useful if available, can be substituted with com- mercially available tools. Except where otherwise instructed, install parts is the reverse order of removal.
Instructions and precautions for installing part are shown with [*1] mark in the INSTALLATION Section, identifying which step the instructions are intended for. Marks shown in the INSTALLATION Section stand for the following. k This mark indicates safety-related pre- cautions, which must be followed when doing the work. a This marks gives guidance or precau- tions when doing the procedure. 2) Distinction of new and existing special tools. N: Tools with new part numbers, newly developed for this model. R: Tools with upgraded part numbers, remodeled from already available tools for other models. Blank: Tools already available for other models, used without any modification.
3) Circle mark ( Q ) in sketch column. A circle mark means that a sketch of the spe- cial tool is presented in the section of Sketches for Special Tools. a Part No. of special tools starting with 79*T means that they are locally made parts and as such not interchangeable with those made by Komatsu in Japan e.g. 79*T---ЧЧЧ---ЧЧЧЧ. 2 This mark stands for a specific coating agent to be used. 3 This mark indicates the specified torque. 5 This mark indicates an amount of oil or water to be added. SKETCHES OF SPECIAL TOOLS Various special tools are illustrated for the con- venience of local manufacture.
REMOVAL OF PARTS The REMOVAL Section contains procedures, precautions and the amount of oil or water to be drained. Various symbols used in the REMOVAL Section are explained and listed below. k This mark indicates safety-related pre- cautions, which must be followed when doing the work. a This mark gives guidance or precautions when doing the procedure. [*1] This mark shows that there are instruc- tions or precautions for installing parts. 6 This mark shows oil or water be drained. 4 This mark shows the weight of a part or a device. D85EX-15 30-3 (2)