DISASSEMBLY AND ASSEMBLY POWER TRAIN UNIT 35. Pull out drive shaft (39) according to the follow- ing procedure. Using forcing screw [1], pull out the drive shaft until the spline on the steering case side comes off. a If the shaft is difficult to pull out, raise the shoe grouser with a jack and find out a posi- tion where the shaft is pulled out easily. a Pull out the drive shaft on the opposite side similarly. 39. Lift off the power train unit assembly (47). [*3] a Before lifting off the power train unit assem- bly, check that all the wires and pipes are dis- connected. 4 Power train unit assembly: 1,850 kg INSTALLATION 36. Remove cover (41) of the steering case bevel gear shaft.
Carry out installation in the reverse order to removal. [*1] 3 Mounting bolt: 98.1 – 122.6 Nm {10 – 12.5 kgm} 37. Remove cap (42) and loosen coupling clamp (43) and move seal (44) outward. [*2] a Work on the opposite side similarly. [*2] a Clamp the peak of the coupling seal securely and set the clamp threads in parallel with the cap mounting seat. [*3] a When installing the power train unit assem- bly, take care extremely not to damage seal (44). Refilling with oil Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then, check the oil level again. 38.
Remove left mount mounting bolts (45) and right mount mounting bolts (46) on the front side. 5 Power train case: Approx. 100 l 5 Hydraulic tank: D85EX-15; Approx. 150 l D85PX-15; Approx. 140 l 3 Hydraulic tank drain plug: 58.8 – 78.5 Nm {6 – 8 kgm} D85EX-15 30-57 (2)