DISASSEMBLY AND ASSEMBLY HSS 9. Adjustment and installation of speed sensor 1) Remove the locknut from speed sensor (109) and apply LG-5 to its threads generously. 2) Screw the speed sensor into mounting cover (110), and then install the cover to the HSS case. 3) Screw the speed sensor until its tip touches bevel gear (111), and then return it by 1/2 – 1 turn. 4) Remove the speed sensor and cover together and tighten locknut (112). a Tighten the locknut so that the speed sensor will not move. 3 Locknut: 49 – 68.8 Nm {5 – 7 kgm} 5) Install cover (110) and insert connector (113) in the holder. 2 Mating faces of cover and HSS case:
Gasket sealant (LG-1) a Install the cover so that the speed sensor will be on the right side. D85EX-15 30-93 (2)