John Deere S760, S770, S780, and S790 Combines — Emergency Exit

Safety Service Drive Belts Safely When servicing drive belts always observe these precautions: Avoid serious injury from hand or arm entanglement. Never attempt to clean, check or adjust belts while the machine is running. Always shut off the engine, set the parking brake and remove the key. Do not attempt to clean belts with flammable cleaning solvents. TS285 —UN—23AUG88 OUO6075,00026A4 -19-06FEB03-1/1 Handle Electronic Components and Brackets Safely Falling while installing or removing electronic components mounted on equipment can cause serious injury. Use a ladder or platform to easily reach each mounting location. Use sturdy and secure footholds and handholds.

Do not install or remove components in wet or icy conditions. TS249 —UN—23AUG88 If installing or servicing a RTK base station on a tower or other tall structure, use a certified climber. If installing or servicing a global positioning receiver mast used on an implement, use proper lifting techniques and wear proper protective equipment. The mast is heavy and can be awkward to handle. Two people are required when mounting locations are not accessible from the ground or from a service platform. DX,WW,RECEIVER -19-24AUG10-1/1 Avoid Backover Accidents Before moving machine, be sure that all persons are clear of machine path. Turn around and look directly for best visibility.

Use a signal person when backing if view is obstructed or when in close quarters. PC10857XW —UN—15APR13 Do not rely on a camera to determine if personnel or obstacles are behind the machine. The system can be limited by many factors including maintenance practices, environmental conditions, and operating range. DX,AVOID,BACKOVER,ACCIDENTS -19-30AUG10-1/1 10-16 070717 PN=35