Komatsu D155AX-6 — E-26 WINDSHIELD WIPER AND WINDOW WASHER DO NOT OPERATE

SEN00807-01 40 Troubleshooting 58 D155AX-6 Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 7 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between fuse (5) – CN14 (female) (3), (5), CN28 (female) (3), CN23 (female) (3), or circuit branch end and chas- sis ground Resis- tance Min. 1 Mz Wiring harness between CN14 (female) (2) – CN29 (female) (3) and chassis ground Resis- tance Min. 1 Mz Wiring harness between CN29 (female) (4) – CN28 (female) (4) and chassis ground Resis- tance Min.

1 Mz Wiring harness between CN28 (female) (5) – CN23 (female) (6) and chassis ground Resis- tance Min. 1 Mz Trouble (3) Front windshield wiper does not operate intermittently. Related information • Before carrying out troubleshooting, check that continuous operation is normal. • If fuse ( -4) is broken, intermittent operation of all windshield wipers becomes defective. • Carry out troubleshooting with front wiper switch and intermittent switch ON. • During intermittent operation, wiper stops for 5 seconds after each cycle of operation.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective intermittent switch (Internal disconnection) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. CN11 (male) Intermittent switch Resistance Between (5) – (6) OFF Min. 1 Mz ON Max. 1 z 2 Defective front wiper inter- mittent selector relay (Inter- nal trouble) a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Replace front wiper intermittent selector relay (Right No.) with another relay.

If front wiper becomes normal at this time, intermit- tent selector relay is defective. CN29 3 Defective front wiper inter- mittent relay (Internal trou- ble) a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Replace front wiper intermittent relay (Right No.) with another relay. If front wiper becomes normal at this time, intermittent relay is defective. CN28 4 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between CN11 (female) (6) – CN29 (female) (1) Resis- tance Max.

1 z Wiring harness between CN29 (female) (5) – CN28 (female) (2) Resis- tance Max. 1 z Wiring harness between CN29 (female) (2) – chassis ground (GND3) Resis- tance Max. 1 z 5 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between CN11 (female) (6) – CN29 (female) (1) or circuit branch end and chassis ground Resis- tance Min. 1 Mz Wiring harness between CN29 (female) (5) – CN28 (female) (2) and chassis ground Resis- tance Min. 1 Mz