50 Disassembly and assembly SEN01205-00 51. Remove three mounting bolts (84) through (86), and remove rocker arm and rocker shaft assembly (87). a Loosen lock nut (89), and loosen adjust- ment screw (90) two or three turns to pre- vent excessive force applied to push rod (88), when installing rocker arm and rocker shaft assembly. [*21] 5) Remove mounting bolt (100) of holder (99). [*25] 6) Set L type bar [1] under fuel injector assembly inlet connector (e), and remove slowly fuel injector assembly (101) with holder using leverage action. [*26] a Do not grip the solenoid valve at the top of the injector to pull off the injec- tor. 52. Remove fuel injector assembly.
1) Remove wiring harness clamping bolt (92) and clip (93). [*22] 2) Remove two wiring harness capture nuts (94) from fuel injector assembly. [*23] a Loosen nuts alternately. 3) Unscrew bolt (95) to remove holder (96). 4) Push connecter (97) into rocker housing, and remove injector wiring harness (98). [*24] a O-ring is installed in connector (97). 53. Remove two push rods (102). D155AX-6 17