Komatsu D155AX-6 — REMOVAL AND INSTALLATION OF CYLINDER HEAD ASSEMBLY

50 Disassembly and assembly SEN01205-00 3) Install cylinder head assembly. 4) Tighten mounting bolts in order of 1 through 6 as shown in the figure. 2. After installing cross head (103), make adjust- ment as follows. 1) Loosen lock nut (111), and loosen adjust- ment screw (112). 2) Lightly push cross head (103) contact sur- face (h) with rocker arm, and hold cross head to contact with push rod (102) side valve stem (113). 3) Screw slowly adjustment screw (112), and check the position where adjustment screw touches valve stem (114). 4) From the above condition, screw adjust- ment screw (112) 20°. 5) While holding adjustment screw (112) with a flat-head screwdriver, tighten locknut (111).

2 Mounting bolt: Lubricant with molybdenum dis- ulfide (LM-P) 3 Mounting bolt 1st time: 137 – 157 Nm {14 – 16 kgm} 2nd time: 284 – 294 Nm {29.0 – 30.0 kgm} 3rd time: Retighten 90° (+30°/0) with tool A4 . a When tool A4 is not available, put marks (a) and (b) to bolt and cylinder head, and retighten bolt 90° (+30°/0). 5) Tighten auxiliary bolt (tightening order: 7th) with the following torque. 3 Locknut: 58.7 ± 5.9 Nm {6.0 ± 0.6 kgm} 3 Auxiliary bolt: 66.6 ± 7.4 Nm {6.8 ± 0.8 kgm} 3. Install push rod (102). a Raise push rod slightly, and check that push rod is securely inserted in cam fol- lower. D155AX-6 19