10 Structure, function and maintenance standard SEN00605-00 Outline Bevel gear shaft q The engine power is transmitted through the torque converter to the transmission. Then, the bevel gear shaft system engages bevel pinion (36) with bevel gear (17) to turn the engine power at a right angle into the lateral direction and reduce the rotation speed. Brake q The brake is connected to the L.H. and R.H. HSS respectively. It controls the power trans- mitted from HSS to final drive to brake the machine. q Brake adopts wet multiple disc clutch type and spring-boosted type, and it is hydraulic actu- ated type which activates brake control valve (5) by the operation of brake pedal.
q The bevel gear shaft system adopts the spiral bevel gear at bevel pinion (36) and bevel gear (17), and it adopts the splash lubrication with the oil from the steering lubrication pump and the scavenging pump for lubrication. q It adopts forced lubrication which sends oil from steering lubrication pump and scavenging pump to case (7) and brake drum (13) through passage inside steering case, and then to brake disc (12) and brake plate (11).
q The bevel gear shaft system consists of bevel pinion (36), bearing (35) which supports bevel pinion, cage (33), bevel gear (17) which meshes with the bevel pinion, bevel gear shaft (16), bearing (25) and (26) which support bevel shaft gear, and retainer (28). q When the engine is stopped, back pressure of brake piston (10) descends even if the brake pedal is not depressed, which initiates the brake to “operate“. However, parking brake lever must be in “lock“ position, because the brake is “released“ as the oil pressure within the circuit rises when the engine is restarted.
HSS q HSS is constructed from transfer area which transmits rotation of HSS motor (39) to gear A (18) by turning it in reverse direction, and the planet area which adjusts inputs from ring gear (22) and sun gear (19) and then outputs to car- rier (24).It changes the turning of the machine by turning off the rotation of HSS motor (39), or by making it move in normal rotation or reverse rotation.
q The brake consists of brake hub (14) attached to carrier (24), brake disc (12) meshed with the brake hub, brake drum (13), brake plate (11) whose outside perimeter meshes with brake drum (13), brake piston (10) and brake spring (9) which bring brake disc and brake plate together, and cylinder (8) which supports all of them, case (7) and output shaft (6). Brake drum (13) and case (7) are fixed to the steering case. Also, output shaft (6) meshes to brake hub (14) by spline and is held by spacer (31) in the axial direction. q The transfer unit employs a spur gear speed reduction mechanism and is lubricated with oil splashed by the steering lubrication pump and scavenging pump.
q Planet area adopts forced lubrication with oil from steering lubrication pump and scavenging pump for lubrication. q The transfer unit consists of drive gear (40) connected to the HSS motor (39) by spline, gear D (41) meshed with the drive gear, gear C (42) meshed with gear D, gear B (37) con- nected to shaft (38), gear A (18) supported by the bearing on the bevel gear shaft and the steering case to support these parts. q The planet area consists of sun gear (19), planetary pinion (21), pinion shaft (20), ring gear (22), hub (23) meshed with bevel gear shaft (16) and ring gear (22), and carrier (24) attached to brake hub (14). D155AX-6 45