Komatsu D155AX-6 — WORK EQUIPMENT CONTROL

10 Structure, function and maintenance standard SEN00607-00 1. Work equipment lock lever 2. Blade control lever 3. Ripper control lever 4. Work equipment lock switch Lever positions A : Blade HOLD B : Blade LOWER B + C :Blade FLOAT D : Blade RAISE E : Blade LEFT TILT F: Blade RIGHT TILT G : Ripper HOLD H : Ripper RAISE J : Ripper LOWER K : Ripper DECREASE TIP ANGLE L : Ripper INCREASE TIP ANGLE M : FREE N : LOCK Outline q The work equipment control employs a EPC method which uses a EPC valve to move each control valve spool. q Work equipment lock lever (1) is interconected with work equipment lock switch (4), and at the FREE position, the oil in the EPC circuit is opened. D155AX-6 7