Komatsu D155AX-6 — CONTROL VALVE

10 Structure, function and maintenance standard SEN00607-00 = P - P2 PO = Differential pressure between ports (H) and (K) • ressure P2 = LSO + PO Function q When steering spool (1) and blade tilt spool (2) are relieved at the same time, the pump pres- sure is separated by pressure compensation valve spool (3) in the blade tilt valve, and the port pressure is maintained at a constant value. q If HSS motor (6) reaches the stall condition, the load pressure increases and LS relief valve (4) for the steering valve is actuated, so the system is cut off. Operation q For details, see “1. Steering valve“.

q When this happens, the pump discharge pres- sure (P) is maintained at 38.2 MPa {390 kg/ cm 2 } and this is sent to chamber (G) of the blade tilt valve. q When blade tilt spool (2) is operated and the load on the blade tilt valve is greater, blade tilt valve LS relief valve (5) is actuated, and drain oil flow (Q1) flows to LS circuit (O). q As a result, a differential pressure is generated on the left and right sides of pressure compen- sation valve spool (3) by LS throttle (M) of blade tilt spool (2), and it moves the full stroke to the right. q When this happens, the opening between chambers (D) and (E) is throttled to the mini- mum size (pump pressure separated).

q Oil flow (Q1) is determined by pump discharge pressure (P) and the total pressure loss (P – LSO) of ports (C), (D), (E), (F), (G), (I), (J) and (K). q Furthermore, pressure (P2) (the pressure in chamber (H)) becomes the total (LSO + PO) of the circuit pressure loss of ports (H), (I), (J) and (K), and the set pressure of work equip- ment LS relief valve (5). D155AX-6 45