Komatsu D155AX-6 — CONTROL VALVE

10 Structure, function and maintenance standard SEN00607-00 Function q It consists of a parallel circuit, so when com- pound operations are carried out, the oil flow is divided according to the size of each spool opening. Operation q When blade tilt spool (1) and blade lift spool (2) are at the “hold“ position or are “operated“, steering priority valve (3) is pushed completely to the right, and the size of the opening to the downstream area is at its maximum. q Blade tilt spool (1) and blade lift spool (2) are actuated by PPC valve output pressure (PA2) and (PB3), and each is balanced at a position that matches its own EPC valve output pres- sure.

When pressure (P2) Z (P3) q Blade lift valve load pressure (P3) is sent to the pump LS valve through LS passage (O). 1) When pump swash plate does not reach maxi- mum angle q When the maximum flow of oil from the pump is greater than the total of the oil flow demanded by the blade tilt valve and blade lift valve, an oil flow that matches the opening of the spool flows to both the blade tilt valve and blade lift valve.

2) When pump swash plate is at maximum angle q When the maximum flow of oil from the pump is smaller than the total of the oil flow demanded by the blade tilt valve and blade lift valve, the flow of oil to the blade tilt valve and blade lift valve is divided according to differen- tial pressure (PO) – (P2) and differential pres- sure (PO) – (P3). q In other words, more oil flows to (P2) where the load is small.

a In cases where the blade is raised above ground and the blade tilt valve and blade lift valve for “raise“ are operated at the same time, the blade tilt valve load pressure is smaller than the blade lift valve load pressure, so the flow of oil to the blade tilt valve is given priority. In addition, the oil flow demanded by the blade tilt valve is smaller, so the condition is just as if priority was given to the oil flow for the blade tilt valve. When pressure (P2) = (P3) (P) – (P2) C (P) – (P3), so an oil flow proportional to the size of the spool opening is distributed to each spool. D155AX-6 49