Komatsu D155AX-6 — 20 STANDARD VALUE TABLE

10 Structure, function and maintenance standard SEN00610-00 Gearshift mode function Outline There are the auto gearshift mode and manual gearshift mode in the gearshift mode. These modes are changed to each other each time gear- shift mode switch (1) is pressed. 1. Auto gearshift mode (Dozing mode) q If a load is applied, the gear is shifted down automatically. When the load is removed, the gear is shifted up to the set maximum gear speed automatically. q The torque converter lockup operates accord- ing to loads and the maximum gear speed is selected automatically. In this mode, less fuel is consumed and more production is obtained. 2.

Manual gearshift mode (Ripping mode) q If a load is applied, the gear is shifted down automatically. When the load is removed, however, the gear is not shifted up automati- cally. Gear shift operation q Set a gear by pressing (a) or (b) of the steer- ing/directional/gearshift lever. (a) Shift-up switch (b) Shift-down switch Display of screen The gearshift mode is displayed in the gearshift mode display section of the monitor panel as shown below. A: Auto gearshift mode 1. Gear speed used currently 2. Preset (gear speed at start) and maximum gear speed during travel 3. Mark of AUTO (which indicates auto gear- shift mode) 4. Mark of Dozing (which indicates auto gearshift mode) B:

Manual gearshift mode 5. Gear speed used currently 6. Preset (gear speed at start) 7. Mark of Ripping (which indicates manual gearshift mode) D155AX-6 27