20 Standard value table SEN00678-01 D155AX-6 7 Machine model D155AX-6 Cate- gory Item Measurement condition Unit Standard value for new machine Service limit value Work equipment Work equipment speed Blade tilt • Hydraulic oil temperature: Within operating range • Engine: High idle • Select P mode • Apply no load to blade • Measure time required to move blade from left tilt end to right tilt end • For measuring posture, see Fig. 2 Left tilt sec 1.8 – 2.8 3.1 Right tilt sec 1.8 – 2.8 3.1 Ripper lift • Hydraulic oil temperature: Within operating range • Engine: High idle • Select P mode • Apply no load to ripper (Shank hole:
Lowest) • Measure time required to move ripper from ground level to raise end • For measuring posture, see Fig. 3 Raise sec 2.0 – 3.0 4.0 Lower sec 1.5 – 2.5 3.5 Ripper tilt • Hydraulic oil tempera- ture: Within operating range • Engine: High idle • Select P mode • Apply no load to ripper • Measure time required to move ripper from tilt in end to tilt back end • For measuring posture, see Fig. 4 Tilt in sec 4.5 – 5.5 6.2 Tilt back sec 3.7 – 4.7 6.1 Time lag Blade • Hydraulic oil temperature: Within operating range • Engine: Low idle • Select P mode. • Blade control lever: Set to stroke end • Lower blade from max.
rising position and measure time after blade comes in contact with ground until idler is lifted sec Max. 1.7 2.5 Ripper • Hydraulic oil temperature: Within operating range • Engine: Low idle • Select P mode • Ripper control lever: Set to stroke end • Lower ripper from max. rising posi- tion and measure time after ripper comes in contact with ground until sprocket is lifted sec Max. 1.5 1.5