30 Testing and adjusting SEN00680-01 Testing and adjusting, Part 2 1 Measuring power train oil pressure 1 a Measuring instruments for power train oil pres- sure k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the LOCK position. a Measure the power train oil pressure under the following condition. a Since the inlet pressure and outlet pressure of the torque converter are measured with the Monitoring function of the service mode of the machine monitor, there are not oil pressure pickup plugs for them in the centralized pres- sure pickup section. q Power train oil temperature:
Within operating range a Since the power trail oil pressure pickup plugs (centralized pressure pickup section) are installed inside the right step cover, remove that cover when measuring the power train oil pressure. a Pressure pickup plugs and gauges to be used D155AX-6 3 Symbol Part No. Part name M 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester No.
Stamp Oil pressure to be measured Oil pressure gauge (MPa {kg/cm²}) 1 TM Transmission main relief pressure 5.9 {60} 2 LU Torque converter lockup clutch pressure 2.5 {25} 3 SC Torque converter stator clutch pressure 5.9 {60} 4 F Transmission forward clutch pressure 5.9 {60} 5 R Transmission reverse clutch pressure 5.9 {60} 6 1ST Transmission 1st clutch pressure 5.9 {60} 7 2ND Transmission 2nd clutch pressure 5.9 {60} 8 3RD Transmission 3rd clutch pressure 5.9 {60} 9 RB Steering right brake pressure 5.9 {60} 10 LB Steering left brake pres- sure 5.9 {60} 11 – Torque converter inlet pressure Machine monitor – Torque converter outlet pressure Machine monitor