SEN00681-01 30 Testing and adjusting Adjustment ID: 7842 (Transmission clutch IP auto- matic initial correction) Adjustment ID: 7843 (Transmission clutch IP man- ual initial correction) q This adjustment code is used to make the power train controller recognize the mechani- cal condition of the transmission. a After the power train controller or transmission is replaced, be sure to carry out this adjust- ment once. q This adjustment code is used to carry out cor- rection manually when the correction is not carried out normally by the operation of IP automatic correction (Adjustment ID: 7842 ). a Use this adjustment code after the IP correc- tion work, if necessary.
q Functions of function switches [F3]: Unused [F4]: Unused [F5]: Return to adjustment item selecting screen (ID inputting screen) [F6]: Save adjustment value q Functions of function switches [F3]: Increase adjustment value [F4]: Decrease adjustment value [F5]: Return to adjustment item selecting screen (ID inputting screen) [F6]: Save adjustment value a If [F2] is pressed while [F1] is pressed, all the correction values are set to 0. q Conditions for correction work 1) [ENGINE SPEED]: 1,700 – 1,950 rpm 2) [T/C TEMPERATURE]: 65 – 85 °C 3) Parking brake lever:
LOCK position a When using this adjustment code, keep the above conditions (In particular, increase the power train oil temperature sufficiently before starting adjustment). q Functions of shift-up and shift-down switches You can select a clutch to be corrected manu- ally with the shift-up and shift-down switches. q Conditions for correction work Same as the conditions for IP automatic cor- rection (Adjustment ID: 7842 ). q Operating method: 1) Start the engine and keep its speed in the specified range of condition with the fuel control dial. 2) Press [F6] and start the correction work and check that [1ST CLUTCH] is dis- played newly on the screen.
3) If [END OF TEACHING] is displayed on the screen, press [F6]. If the alarm buzzer sounds at this time, correction work is completed. a The machine does not move during the correction work. a Even if this adjustment code is turned off, the correction is effective. q Operating method: 1) Start the engine and keep its speed in the specified range of condition with the fuel control dial. 2) Select a clutch to be corrected manually with the shift-up or shift-down switches. 3) Increase or decrease the adjustment value by pressing [F3] or [F4]. 4) Press [F6] and check that the alarm buzzer sounds. a The machine does not move during the correction work.
a Even if this adjustment code is turned off, the correction is effective. 58 D155AX-6