Komatsu D155AX-6 — SPECIAL FUNCTIONS OF MACHINE MONITOR (EMMS)

SEN00681-01 30 Testing and adjusting Cylinder Cut-Out operation The operator can perform Cylinder Cut-Out opera- tion with the machine monitor. Reduced cylinder mode operation means to run the engine with 1 or more fuel injectors disabled electri- cally to reduce the number of effective cylinders. This operation is used to find out a cylinder which does not output power normally (combustion in it is abnormal). 3. Resetting disabled cylinder When changing a cylinder to be disabled or when reduced cylinder mode operation is fin- ished, select a disabled cylinder to be reset with the function switches. a This operation may be performed while the engine is running.

a When [F6] is pressed, if background (a) of the selected cylinder No. becomes light blue, the cylinder is reset. a If the machine monitor rests a disabled cylinder but the engine controller cannot reset that disabled cylinder, the back- ground of the cylinder No. becomes red. a The reduced cylinder mode operation is not automatically reset after the screen returns to the operator mode. Accord- ingly, be sure to perform the resetting operation after the reduced cylinder mode operation is finished. 1. Selecting menu Select "09 Cylinder Cut-Out" on the "Service Menu" screen. 4.

Function of holding displayed information If [F4] is pressed during the reduced cylinder mode operation, the displayed information is newly held (c) (The real-time information is kept displayed on the left side). a While the information is held, if [F3] is pressed, the holding function is reset. a The holding function is effective, regard- less of setting of the reduced cylinder mode operation. 2. Selecting cylinder to be disabled After the "Cylinder Cut-Out" screen is dis- played, select a cylinder to be disabled with the function switches. q [F1]: Move selection mark ( R ) to left q [F2]: Move selection mark ( R ) to right q [F3]: Reset holding q [F4]: Hold q [F5]:

Return to service menu screen q [F6]: Confirm selection a This operation may be performed while the engine is running. a When [F6] is pressed, if background (a) of the selected cylinder No. becomes white, the cylinder is disabled. a If the machine monitor disables a cylinder but the engine controller cannot disable that cylinder, the background of the cylin- der No. becomes yellow. a One or more cylinders can be disabled. [Reference] q If a normally operating cylinder is disabled, the following phenomena occur.

1) Lowering of engine speed 2) Increase of final injection rate command (quantity) q If the engine is running near the high idle, how- ever, the engine speed may not lower for the reason of engine control. q In this case, lower the engine speed with the fuel control dial and judge by increase of the injection rate command. 72 D155AX-6