Komatsu D155AX-6 — CLASSIFICATION AND PROCEDURES FOR TROUBLESHOOTING

SEN00851-00 40 Troubleshooting Phenomena looking like troubles and troubleshooting Nos. 6 D155AX-6 No.

Phenomena looking like troubles Troubleshooting Display of code E mode H mode S mode Phenomena related to action code/failure code 1 Action code and failure code are displayed on machine monitor Accord- ing to dis- played code 2 When fault history is checked, failure code is displayed in mechanical system fault history 3 When fault history is checked, failure code is displayed in electrical system fault history 4 When fault history is checked, failure code is displayed in air conditioner or heater fault history E-20 Phenomena related to engine 5 Starting performance is poor S-1 6 Engine does not start E-3 S-2 7 Engine does not pick up smoothly S-3 8 Engine stops during operation S-4 9 Engine does not rotate smoothly S-5 10 Engine lacks output (or lacks power) S-6 11 Exhaust smoke is black (incomplete combustion) S-7 12 Oil consumption is excessive (or exhaust smoke is blue) S-8 13 Oil is contaminated badly S-9 14 Fuel consumption is excessive S-10 15 Oil is in coolant (or coolant spurts back or coolant level goes down) S-11 16 Oil pressure drops S-12 17 Oil level rises (Entry of coolant/fuel) S-13 18 Coolant temperature becomes too high (overheating) S-14 19 Abnormal noise is made S-15 20 Vibration is excessive S-16 21 Preheater does not operate E-4 Phenomena related to power train 22 Power is low (Drawbar pull is low) H-1 23 Machine does not travel (at 2nd or 3rd gear speed) H-2 24 Machine does not start at any gear speed H-3 25 Machine can travel only forward or in reverse H-4 26 When gear speed or travel direction is changed, time lag is large H-5 27 Machine cannot be steered (Machine does not turn right or left) H-6 28 Steering speed or steering force is low H-7 29 Brake does not work H-8 30 Power train oil is overheated H-9 31 Abnormal sound comes out from around HSS pump or HSS motor H-10 Phenomena related to work equipment 32 Speed of all work equipment is low H-11 33 No work equipment moves H-12 34 Blade lift speed or power is low H-13 35 Blade tilt speed or power is low H-14