Komatsu D155AX-6 — INFORMATION IN TROUBLESHOOTING TABLE

SEN00716-01 40 Troubleshooting Information in troubleshooting table 1 a The following information is summarized in the troubleshooting table and the related electrical circuit dia- gram. Before carrying out troubleshooting, understand that information fully.

14 D155AX-6 Action code Failure code Trouble Trouble name displayed in fault history of machine monitor Display on machine moni- tor Display on machine monitor Contents of trouble Contents of trouble detected by machine monitor or controller Action of machine moni- tor or controller Action taken by machine monitor or controller to protect system or devices when they detect trouble Problem that appears on machine Problem that appears on machine as result of action taken by machine monitor or controller (shown above) Related infor- mation Information related to detected trouble or troubleshooting Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Possible causes of trouble (Given numbers are refer- ence numbers, which do not indicate priority) • Standard value in normal state to judge possible causes • Remarks on judgment • Disconnection Connector is connected defectively or wiring harness is broken.

• Ground fault Wiring harness which is not connected to chassis ground circuit is in contact with chassis ground circuit. • Hot short Wiring harness which is not connected to power source (24 V) circuit is in contact with power source (24 V) circuit. • Short circuit Independent wiring harnesses are in contact with each other abnormally. (1) Method of indicating connector No. and handling of T- adapter Insert or connect T-adapter as explained below for trouble- shooting, unless otherwise specified. • If connector No. has no marks of "male" and "female", disconnect connector and insert T-adapters in both male side and female side. • If connector No.

has marks of "male" and "female", dis- connect connector and connect T-adapter to only male side or female side. (2) Entry order of pin Nos. and handling of tester leads Connect positive (+) lead and negative (–) lead of tester as explained below for troubleshooting, unless otherwise specified. • Connect positive (+) lead to pin No. or wiring harness entered on front side. • Connect negative (–) lead to pin No. or harness entered on rear side. 2 3 4