Komatsu D155AX-6 — FAILURE CODE [15SEL1] SPEED 1ST CLUTCH: FILL HIGH

40 Troubleshooting SEN00716-01 Failure code [15SEL1] Speed 1st clutch: Fill high 1 Circuit diagram related to transmission 1st clutch ECMV D155AX-6 21 Action code Failure code Trouble Speed 1st clutch: Fill high (Power train controller system) E03 15SEL1 Contents of • trouble When output to transmission 1st clutch ECMV solenoid circuit is turned OFF, fill switch signal is turned ON. Action of • controller Limits operation of engine and transmission. Problem that • appears on • machine Once machine is stopped, engine speed is limited to medium (half). Once machine is stopped, travel is limited to F1 and R1.

• Related • information • State of 1st clutch ECMV fill switch signal can be checked with monitoring function. (Code: 40906 T/M Fill Sw Input 1) Method of reproducing failure code: Start engine + Set transmission in neutral. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Defective 1st clutch ECMV 1 fill switch (Internal short cir- cuit) a Prepare with starting switch OFF, then start engine, select manual gearshift mode, and carry out troubleshooting. F1T (male) PCCS lever (Travel gear speed) Resistance Between (1) – chas- sis ground Other than F1, N, or R1 Min. 1 Mz F1, R1 Max.

1 z Ground fault in wiring har- 2 ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC3 (female) (19) – F1T (female) (1) and chassis ground Resis- M tance in. 1 Mz Defective power train con- 3 troller a Prepare with starting switch OFF, then start engine, select manual gearshift mode, and carry out troubleshooting. STC3 PCCS lever (Travel gear speed) Voltage Between (19) – chas- sis ground Other than F1, N, or R1 5 – 11 V F1, R1 Max. 1 V I 4 Defective hydraulic system t f causes 1 – 3 are not detected in electrical system, hydraulic sys- em may be defective.

Carry out related troubleshooting (H mode).