40 Troubleshooting SEN00716-01 Failure code [15SFL1] Speed 2nd clutch: Fill high 1 Circuit diagram related to transmission 2nd clutch ECMV D155AX-6 23 Action code Failure code Trouble Speed 2nd clutch: Fill high (Power train controller system) E03 15SFL1 Contents of • trouble When output to transmission 2nd clutch ECMV solenoid circuit is turned OFF, fill switch signal is turned ON. Action of • controller Limits operation of engine and transmission. Problem that • appears on • machine • Auto-shift-down function does not operate. Once machine is stopped, engine speed is limited to medium (half). Once machine is stopped, travel is limited to F2 and R2.
• Related • information • State of 2nd clutch ECMV fill switch signal can be checked with monitoring function. (Code: 40906 T/M Fill Sw Input 1) Method of reproducing failure code: Start engine + Set transmission in neutral. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Defective 2nd clutch ECMV 1 fill switch (Internal short cir- cuit) a Prepare with starting switch OFF, then start engine, select manual gearshift mode, and carry out troubleshooting. F2T (male) PCCS lever (Travel gear speed) Resistance Between (1) – chas- sis ground Other than F2, N, or R2 F2, R2 Min. 1 Mz Max.
1 z Ground fault in wiring har- 2 ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC3 (female) (29) – F2T (female) (1) and chassis ground Resis- tance Min. 1 Mz Defective power train con- 3 troller a Prepare with starting switch OFF, then start engine, select manual gearshift mode, and carry out troubleshooting. STC3 PCCS lever (Travel gear speed) Voltage Between (29) – chas- sis ground Other than F2, N, or R2 F2, R2 5 – 11 V Max. 1 V 4 Defective hydraulic system If causes 1 – 3 are not detected in electrical system, hydraulic sys- tem may be defective.
Carry out related troubleshooting (H mode).