40 Troubleshooting SEN00716-01 Failure code [15SGL1] Speed 3rd clutch: Fill high 1 Circuit diagram related to transmission 3rd clutch ECMV D155AX-6 25 Action code Failure code S Trouble ( peed 3rd clutch: Fill high Power train controller system) E03 15SGL1 Contents of • trouble When output to transmission 3rd clutch ECMV solenoid circuit is turned OFF, fill switch signal is turned ON. Action of • controller Limits operation of engine and transmission. Problem that • appears on • machine • Auto-shift-down function does not operate. Once machine is stopped, engine speed is limited to medium (half). Once machine is stopped, travel is limited to F3 and R3.
• Related information • State of 3rd clutch ECMV fill switch signal can be checked with monitoring function. (Code: 40906 T/M Fill Sw Input 1) Method of reproducing failure code: Start engine + Set transmission in neutral. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting a Defective 3rd clutch ECMV 1 fill switch (Internal short cir- cuit) B s Prepare with starting switch OFF, then start engine, select manual gearshift mode, and carry out troubleshooting. F3T (male) PCCS lever (Travel gear speed) Resistance etween (1) – chas- is ground Other than F3, N, or R3 Min. 1 Mz F3, R3 Max.
1 z a Ground fault in wiring har- 2 ness (Contact with GND cir- W cuit) – Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. iring harness between STC3 (female) (39) F3T (female) (1) and chassis ground Resis- Mi tance n. 1 Mz a Defective power train con- 3 troller B s Prepare with starting switch OFF, then start engine, select manual gearshift mode, and carry out troubleshooting. STC3 PCCS lever (Travel gear speed) Voltage etween (39) – chas- is ground Other than F3, N, or R3 5 – 11 V F3, R3 Max. 1 V If 4 Defective hydraulic system t causes 1 – 3 are not detected in electrical system, hydraulic sys- em may be defective.
Carry out related troubleshooting (H mode).