Komatsu D155AX-6 — FAILURE CODE [2302L1] LEFT BRAKE: FILL HIGH

SEN00716-01 40 Troubleshooting Failure code [2302L1] Left brake: Fill high 1 Circuit diagram related to steering case left brake ECMV 34 D155AX-6 Action cod e Failure code Trouble Left brake: Fill high (Power train controller system) E04 2302L1 Contents trouble of • When output to steering case left brake ECMV solenoid circuit is turned OFF, fill switch signal is turned ON. Action o controlle f • Limits operation of engine, transmission, and brake. r Problem th appears o machine at • Applies brake lightly during travel. n • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, machine cannot travel at all.

Related informatio • State of left brake ECMV fill switch signal can be checked with monitoring function. (Code: 31521 S/T Fill Sw Input) n • Method of reproducing failure code: Start engine + Operate parking brake lever (Free) + Operate brake pedal (Press).

Possible cau and standa value in nor state Cause Defective left brake ECMV fill 1 switch (Internal short circuit) ses Ground fault in wiring har- rd 2 ness (Contact with GND cir- mal cuit) Defective power train con- 3 troller 4 Defective hydraulic system Standard value in normal state/Remarks on troubleshooting Defective left brake ECMV fill switch (Internal short circuit) a Prepare with starting switch OFF, then start engine, set parking brake lever in Free position, and carry out troubleshooting. FBRL (male) Brake pedal Resistance Between (1) – chas- sis ground Released Max. 1 z Pressed Min.

1 Mz Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC2 (female) (2) – FBRL (female) (1) and chassis ground Resis- tance Min. 1 Mz Defective power train con- troller a Prepare with starting switch OFF, then start engine, set parking brake lever in Free position, and carry out troubleshooting. STC2 Brake pedal Voltage Between (2) – chas- sis ground Released Max. 1 V Pressed 5 – 11 V Defective hydraulic system If causes 1 – 3 are not detected in electrical system, hydraulic sys- tem may be defective. Carry out related troubleshooting (H mode).