SEN00716-01 40 Troubleshooting Failure code [B@HANS] Hyd Oil Overheat 1 44 D155AX-6 Action code Failure code Trouble Hyd Oil Overheat (Machine monitor system) — B@HANS Contents of trouble • While engine was running, hydraulic oil temperature sensor signal circuit detected that hydraulic oil was overheated. Action of controller • Displays hydraulic oil temperature monitor red on machine monitor. Problem that appears on machine • If machine is used as it is, work equipment and HSS circuit components may be damaged. Related information • Hydraulic oil temperature can be checked with monitoring function. (Code: 04401 Hyd Oil Temperature) • Method of reproducing failure code: Start engine.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Overheated hydraulic oil (When system is normal) Check hydraulic oil for overheating. If it is overheated, remove cause. 2 Defective hydraulic oil tem- perature gauge system If cause 1 is not detected, hydraulic oil temperature gauge system may be defective. Carry out troubleshooting for "E-10 Hydraulic oil temperature gauge (Multi-gauge) does not indicated normally" in E mode.